| | |  Consulter le certificat | |
Pool alarm Sensor Premium is equipped with a technology which detects the disturbances and analyzes the fall of a body in your pool.
It informs you by the release of a powerful siren after a few seconds.
A continuous analysis of its environment enables it to adapt its operation to the surrounding conditions and thus to avoid inopportune releases.
The starting is made in any simplicity, through a key with impulse.
When you go to bathe, you approach a magnetic key of the device to put it in mode "bathing": the alarm is prevented and will not start during the bath.
If you forget to switch on the device once you've leave the swimming pool, it will turn automatically in surveillance mode.
The response time depends on the volume of the swimming pool and on the weight of the body.
If a 7 kg body (weight of a 7-8-month-old child) penetrates into a pond of 40 M3, even irregular shape tending to delay the distribution of the waves, the release of the siren is made in 6-12 seconds if the place of the fall is 8 metres of the device.
The more the weight is important and the device close to the place of fall, the faster will be the release of the alarm which can vary from 1 till 20 seconds.
Que faire en cas d'alarme ?
|
 |
 |
In case of fall in the water and of release of alarm it is up to you to react very quickly and to take the measures which are imperative.
To stop the sirens: you will have to act directly on the device.
If you are not able to make it, know that sirens are going to work during 1 minute 30, then break off 30 seconds to start again during 1min30 and this 6 times in succession.
Beyond 6 times, and if, naturally, you did not interrupt the cycle, sirens will stop AUTOMATICALLY to start again only in case of a new alert.
Pool alarm Sensor Premium settles on the deck thanks to 4 screws and no cables. You do not need a professional for its installation.
Where do I install my Sensor Premium ?
|
 |
 |
Sensor Premium can be used for pools till 10 M x 5 M. |
Limits imposed by Norm NF P 90-307/A1
|
 |
 |
The device must be installed so that no more than 12 seconds between a fall and the launching of post office foghorn (a priori, it belongs therefore to the owner to make tries from the points of possible fall + distant make tries from the points of possible fall + moved away according to these criteria likely to vary according to dimensions and form of its swimming pool - If the delay is superior in 12 dryness. it will be necessary to divide 2 warning devices
RECALL: The time of reaction depends on the volume of the swimming pool and the weight of the body. If a 7 kg body (weight of a child old of 7-8 months) enters a basin of 40 M3, even of irregular form having tendency to postpone the spread of waves, the siren will start
Precautions of installation
|
 |
 |
The swimming pool must not present a sweet sloping entrance; the slope should be lower than 30 % (Californian swimming pool of type). Beyond 30 %, the installation of alarm is authorized, however, this type of safety remains disadvised because it loses in efficiency.
Does not suit for swimming pools "overflowing " or of type "mirror"
For swimming pools the superior in 10m x 5m, it will be necessary to install 2 or more pool alarms.
Sensor Premium is compatible with most of the systems of filtration and cleaning, except certain robots of cleaning like " robot diver " (which enters and comes out of the water) whose action is comparable to the one that could produce the fall of a child in the water.
 Pool alarm Sensor Premium opened |
The "SENSOR" is preset in factory for a "typical" swimming pool of dimensions 4 x 8 metres.
For other swimming pools, the regulations can easily remit in a series of 5 micro-switches which prefigure the other "typical" dimensions: 3 M x 6 M, 5 x 10 M, 6M x 12 M |